Encoder value consistently reads 0 in the new camera software

Verify that the signal cable connecting the Y-axis driver to the camera is connected correctly. After connecting the signal cable, measure the voltages at terminals A+/A- and B+/B- to ensure they are within the normal range. Confirm that the motor version is compatible with the pin configuration of the signal cable connection. Adjust the pin connection method to match the specific version of the current driver (refer to the driver's instruction manual). Verify that the current pin outputs are functioning correctly. Attempt an alternative wiring configuration.

Software error—"Ink Stack Abnormal" or "Limit Switch Lost."

Replace the ink stack limit switch. Check if the signal cable for the ink stack motor is loose. Verify that the ink stack moves smoothly; apply a small amount of lubricant if necessary.

In the new camera software, the print output appears shifted toward the rear relative to the visual alignment

Verify that the Y-axis gear ratio is set correctly. Verify that the visual alignment calibration is accurate. Verify that the camera's physical vertical alignment is correct. Recalibrate the X-axis and Y-axis gear ratios. Recalibrate the visual alignment. Calibrate the camera's horizontal and vertical positioning.

When printing very fine Arabic text using crystal labels, the text tends to peel off easily

Print the text multiple times (in multiple passes); this ensures that the fine details remain adhered and are not inadvertently removed during the film-peeling process.

Products printed using a machine configured with two varnish printheads (W C V V configuration) fail to cure properly

Add an additional set of curing lamps, or alternatively, print using only three printheads.

After the hot stamping process is complete, the C-film fails to adhere, and the printed image cannot be successfully transferred (peeled off)

1. The C-film may have been applied with the incorrect side facing down; perform a test to verify the correct orientation of the film. 2. The wrong type of C-film was used; ensure that the correct C-film is utilized. 3. The temperature setting is inappropriate; the film-transfer temperature should be set to approximately 90°C.

Get Your QuoteGet Your Quote

FAQs

Encoder value consistently reads 0 in the new camera software
Software error—”Ink Stack Abnormal” or “Limit Switch Lost.”
In the new camera software, the print output appears shifted toward the rear relative to the visual alignment
When printing very fine Arabic text using crystal labels, the text tends to peel off easily
Products printed using a machine configured with two varnish printheads (W C V V configuration) fail to cure properly
After the hot stamping process is complete, the C-film fails to adhere, and the printed image cannot be successfully transferred (peeled off)

Let’s start now on working together.

Contact Info

No.7 Qianshan Road, Anxi Industrial Park, Yuhang District, Hangzhou, Zhejiang Province

(86) 138 0651 3484

FAQs

FAQs

Encoder value consistently reads 0 in the new camera software

Software error—”Ink Stack Abnormal” or “Limit Switch Lost.”

In the new camera software, the print output appears shifted toward the rear relative to the visual alignment

When printing very fine Arabic text using crystal labels, the text tends to peel off easily

Products printed using a machine configured with two varnish printheads (W C V V configuration) fail to cure properly

After the hot stamping process is complete, the C-film fails to adhere, and the printed image cannot be successfully transferred (peeled off)

Let’s start now on working together.

Contact Info